|
|
Operating specifications for mold temperature machines
1. Open the valves leading to the mold and cooling water according to the marks on the mold temperature machine;
2. Check whether the valves of the inlet and outlet circuits of the mold temperature machine are open;
Connect the Teflon pipe leading to the mold according to the identification on the mold heater and the mold water channel structure. The redundant inlet and outlet circuits on the mold heater need to be short-circuited for self circulation;
4. Turn on the three-phase power supply on the device;
5. Start the pump switch, and after the self detection of the temperature control meter, please follow the following steps to set the control temperature:
a. Press the SET key to set the SV flash;
b. Press the up, down, left, and right keys to set the desired temperature, and then press the SET key to restore;
Note: PV is the actual operating temperature value, and the parameters in the instrument have been set before leaving the factory. Do not privately change the parameters set in the instrument;
6. Turn on the heating switch, discharge the gas from the mold water channel and connecting pipe, and heating can automatically heat to the set temperature, automatically adjust the temperature, and maintain a constant temperature;
7. When stopping the machine to disassemble the mold, first turn off the heating switch, and first lower the set temperature to a certain temperature;
8. During oil suction, after the oil temperature drops to a safe temperature, please suck the oil in the mold cavity back as follows:
A. Connect the air source of the mold heater;
b. Manually press the pump switch (green button on the device) and observe the oil gauge of the mold temperature machine to prevent overfilling the oil tank. If the oil tank is too full, the oil in the mold temperature machine needs to be collected into a dedicated storage tank.
c. After oil suction is completed, remove the Teflon tubes from the mold and place them in an orderly manner to prevent oil leakage.
9. After completing the work, turn off the power switch. www.jiashengsz.com
|
| 〖Close Page〗 |
|
1688 shop 
Weibo 
Technical Info